If you want to get in terms of size, shape or performance and other aspects of relatively high quality drawing products, then usually require a number of drawing to complete. In order to meet this requirement, we not only need to ensure the performance and quality of the Wire Drawing Machine equipment, but also should choose the appropriate mold, otherwise, it is difficult to achieve the desired results.
And we choose the mold, it is necessary according to the actual requirements of the finished product to determine the number of combined pull, as well as the number of holes required for the shape of the hole size of the work. Therefore, if you can use the mold in the time, to be correct and reasonable, then will meet the processing requirements at the same time, as far as possible to reduce the number of pull and cracks, cracks and other defects appear. So, for the co-tank Wire Drawing Machine, how do we choose the right mold?
First of all, we need to ensure that the selected mold should meet the quality requirements of the conditions, as much as possible to reduce the number of pull. In other words, the choice of the tank Wire Drawing Machine drawing die should be able to make full use of metal plasticity, improve productivity, reduce energy consumption, and also to minimize the degree of uneven deformation. Therefore, it is necessary to ensure the stability of the process of drawing, as much as possible to increase the extension of each pass.
The second problem, in the process of drawing, should ensure that the resulting deformation is small, and more uniform, so as to ensure that the surface quality of the drawing products, the precise size, and good performance. Thirdly, the selected mold should also be compatible with the parameters of the existing wire Wire Drawing Machine equipment and the equipment capacity.
In summary, in the process of selecting the mold, we should ensure the quality of the product under the prerequisite, as much as possible to increase the Wire Drawing Machine each pass of the extension coefficient, and should also be able to with the existing drawing equipment performance parameters be consistent.