Home > Exhibition > Content

Instructions for safe use of water tank type wire drawing machine

Nov 11, 2020

Water tank wire drawing machine is a widely used mechanical equipment in the industrial field. It has been widely used in machinery manufacturing, hardware processing, petrochemical, plastic, bamboo and wood products, wire and cable industries. For different wire drawing requirements, users can choose corresponding specifications and types of water tank type wire drawing machine equipment. Of course, it also needs to be operated in accordance with the specifications in actual use.

First of all, before turning on the water tank type wire drawing machine equipment, the staff needs to conduct a comprehensive inspection of the equipment, including water level, water quality, oil level, water tank, air pump, etc., and also check the fastening of the spool take-up machine And lubrication and so on. During the inspection, if there are sundries in the motor heat dissipation groove, it should be cleaned up to ensure the ventilation and cooling effect of the motor. In addition, pay attention to check whether there is any sundries on the water tank tower wheel, motor belt and reel, and whether the safety protection device is complete and normal, otherwise you cannot drive.

Secondly, after turning on the equipment, the water tank type wire drawing machine should be operated at a low speed for a while, and the operating speed should be increased after confirming that there is no abnormality. Note that during the operation of the equipment, if any water leakage, oil leakage, or abnormal noise is found, it should be stopped immediately for maintenance, and it cannot be operated with illness.

After the production task is completed, it should be stopped in accordance with the regulations. At this time, it is necessary to gradually reduce the running speed of the water tank type wire drawing machine, and then press the stop button. But in emergency stop, you can press the stop button first. During normal shutdown, first turn the speed control knob of the electromagnetic speed governor to the middle and low speed gears, and then close the clutch switch, then the reel and the spool will automatically stop running.

It should be noted that during the operation of the water tank type wire drawing machine, no other irrelevant persons are allowed to stay around, especially no one should stand near the reel to prevent the wire from being thrown out and hurting people. In order to maintain the stable operation of the water tank type wire drawing machine equipment, its bearings should be lubricated and maintained every 3 months.

https://www.chinawiredrawingmachine.com