Home > Exhibition > Content

Detailed explanation of operation procedure for copper wire drawing machine

Jan 19, 2018

As an operator, we should not only to master the operation rules of the copper wire drawing machine, but also to be trained in safety technology, otherwise, it is not allowed to work on the platform.In the actual production process, the staff must follow the operating procedures strictly.

Before opening the copper wire drawing machine, the operator must first wear the corresponding safety protective equipment.Before starting up, the equipment and safety device should be checked.If the safety device is not reliable, then the equipment should not be opened.During the use, the internal parameters of the converter shall not be adjusted at will.

In addition, we need to maintain a good working environment in the field. It is not necessary to place objects on the rotating parts of the copper wire drawing machine equipment or to avoid the accidents.It is important to note that during the annealing process, when the steam is passed through, it is not allowed to open the anneal protection shield so as not to be burned.

During the whole operation, the staff should not only observe the operation state of the copper wire drawing machine, ensure its safe operation, but also try to protect itself.Do not directly use the hand to detect the tension size, so as to avoid burns, scratches and so on.Proper safety distance should be maintained when using the welder joint in case of a splash of Martian burn.

During the production process, the staff shall not leave the machine without any reason, and should pay attention to the operation state of the copper wire drawing machine.If any abnormality is found, the inspection should be stopped in time and the workshop leader should be reported if necessary.

If a power failure occurs during the operation of the copper wire drawing machine, the staff needs to cut off the power switch immediately and adjust the controller to zero.During the operation of the copper wire drawing machine, no reversal is allowed.http://www.chinawiredrawingmachine.com/