Home > Exhibition > Content

Water tank type wire drawing machine transformation process requirements

Sep 15, 2019

When using conventional wire drawing equipment for drawing operations, there are often problems that can be very troublesome for the user. This is because the control method of the external PID controller is used in the water tank type wire drawing machine equipment, so it will exhibit such defects during the operation: the control parameters are difficult to debug, expensive, and easy to damage.

Moreover, when repairs occur after a problem occurs, the cost is also relatively high. We know that for the water tank type wire drawing machine, when we are drawing, we hope to keep the synchronization in the process of winding and unwinding, and there is no problem of wire breakage. Therefore, in order to solve the above mentioned problems, we need to modify them.

So, what is the process requirement for the transformation process? First of all, when the transformation is carried out, the low frequency torque should be fully reflected. That is to say, during the low frequency point threading, sufficient torque should be maintained and a faster response speed should be maintained. In addition, the water tank type wire drawing machine has no jitter and chattering during the operation.

The second requirement is that during the start and stop of the host, there should be no abnormal problems such as disconnection. If there is a disconnection problem, the alarm should be immediately and emergency stop. The third requirement is that the water tank type wire drawing machine equipment should be able to maintain a smooth running state during the operation. In addition, the pendulum bar is not allowed to collide with the upper and lower limits during normal operation.

One requirement is that when the production task is completed, the water tank type wire drawing machine equipment should be kept in sync and there is no problem of disconnection.

https://www.chinawiredrawingmachine.com/