Home > Exhibition > Content

Treatment method for installation and adjustment of inverted wire drawing machine

Jan 11, 2021

Compared with the ordinary wire drawing machine, the inverted wire drawing machine is actually more important for drawing thicker metal wires. Before installation, be sure to choose an appropriate location. Place the inverted wire drawing machine on a stable ground and install it according to the instructions.

First, according to the foot hole of the machine base, use suitable expansion screws to fix it on the pre-built cement foundation to fix it. Then check whether the equipment can maintain a stable state, and whether all auxiliary equipment is complete. When tightening the equipment, pay attention to adjusting the position of the host to ensure that the center of the reel and the turning center of the trolley are at the same position.

At the same time, when adjusting the host, make sure that the trolley can keep smooth when moving forward and backward. In addition, it is necessary to reasonably connect the electrical wiring of the equipment according to the requirements of electricity use to ensure that there is no leakage or short circuit. After the installation is complete, debugging is followed.

Before that, we need to check whether the installation is complete and check whether the bolts are well tightened. Then pour an appropriate amount of lubricating oil into the gearbox of the inverted wire drawing machine, and check the center position through the observation hole to ensure that the height is suitable. In addition, care should be taken to ensure that there is no oil leakage in the reducer case. After that, make it start under no-load condition. At this time, pay attention to check whether its running state can be kept stable, whether there will be greater noise, or obvious vibration problems. During no-load operation, try to manipulate the control buttons to control the start, normal operation, stop and other actions of the whole machine.