Home > Exhibition > Content

The operation steps of copper wire drawing machine are briefly introduced.

Apr 14, 2018

Before the production, the quality inspector must first check the copper wire drawing machine, and then the equipment can be turned on after qualification. Switch the switch on the small operating table of the copper wire drawing machine and switch on the control power. The controller is energized. The display window displays the initial information and starts to enter the parameter setting.

Next, the main operation of the main engine is to keep the copper wire drawing machine in a static state. After the main engine inverter is connected, tap the pedal switch to operate. At this time, select the whole line starting, if the operation protection has no action, the equipment will start to start; If the protection action is run, the device cannot start. At this time, it is necessary to check whether the lubricating oil pressure is normal and the brake is lifted. At the start of the uplift stage, observe the host, the receiving line of the synchronous condition, if not synchronous, press the stop button.

After the copper wire drawing machine is down, adjust it accordingly and restart. After a period of rising speed, the line should be observed. There should be no pile or collapse at both ends of the reel. If necessary, adjust the line limit switch to make the line even. There is a line speed adjusting potentiometer on the fuselage, which can adjust the line speed.

During the operation of the copper wire drawing machine, the operating personnel on site also need to adjust the annealing voltage properly. It is usually in the automatic tracking state, changing the "annealing coefficient" can change the annealing voltage online, increase the annealing coefficient, and the annealing voltage is raised, whereas the annealing voltage is reduced. In the manual state, changing the "annealing voltage" can change the annealing voltage online.

After the drawing is finished, press the stop button to slow down the device until it is down. Or set the meter length to, the copper wire drawing machine start to slow down to stop. In case of emergency, it is necessary to close the wire drawing machine. In case of emergency, press the emergency stop button to close the lock.http://www.chinawiredrawingmachine.com/