Home > Exhibition > Content

Safety precautions for operating aluminum wire tank type wire drawing machine

Oct 09, 2019

When operating the aluminum water tank type wire drawing machine, the staff must abide by the relevant regulations. Only in this way can we ensure that our production work is completed smoothly. So, what security issues should we pay attention to when operating the device? Here we will introduce, I hope to help you better use the aluminum wire tank type wire drawing machine.

First of all, the operator of the aluminum wire tank type wire drawing machine should be clearly specified, and the operator of the position should not operate the machine without approval. In addition, no one should remove the safety device at will, nor allow the parts to be replaced. Secondly, it should be ensured that the jog switch of the device remains sensitive. When not in use, it should be placed in a concealed place to avoid misoperation.

Thirdly, when operating the molding machine, the staff should pay special attention to protect their personal safety. Do not put your hands on the rotating part of the molding machine, or put your hands on the roller of the molding machine. The power should be turned off in time after the use of the die cutter. Fourth, wear protective glasses when connecting the joints to prevent sparks from flying out. The fifth point is that when the aluminum wire tank type wire drawing machine is running, the equipment must not be repaired or cleaned to avoid accidents.

The sixth point should be to clean all the debris on the equipment before opening the aluminum water tank type wire drawing machine, so as not to get involved in the equipment and cause an accident. The seventh point is that you should not use loose cores or damaged ones. In addition to this, it should be noted that no one other than the staff member appears around the equipment.

When operating an aluminum wire tank type wire drawing machine, if an open flame is found, it must be extinguished in time. If the manual cannot be extinguished, stop the power supply first, then use a fire extinguisher to align with the root of the flame. Fire extinguishers after use should be stored at the designated location.https://www.chinawiredrawingmachine.com/