Home > Exhibition > Content

Safe operation and design concept of inverted wire drawing machine

May 17, 2019

The inverted wire drawing machine adopts the latest high-speed motor control special chip DSP in operation, ensuring fast response of vector control, modular design of hardware circuit, ensuring stable and efficient operation of the circuit, design combined with European car design concept, smooth lines and beautiful appearance.

The inverted wire drawing machine adopts independent air duct design, the fan can be freely disassembled, and the heat dissipation is good. There is no PG vector control, PG vector control, torque control, V/F control can select powerful input and output multi-function programmable terminal. , speed pulse input, two analog output.

Safe operation of inverted wire drawing machine

(1) The operator must wear gloves to prevent the workpiece from burning fingers and affecting product quality.

(2) Before starting the machine, carefully check the supply air of the equipment, whether the gas supply line leaks, and discharge the accumulated water in the air filter.

(3), correctly install the drawing abrasive belt (the direction of the arrow inside the drawing belt should be the same as the direction of the arrow on the drawing roller). Carefully check whether the upper and lower bearing housings and the lifting screw are well lubricated, and make sure that the front side of the discharge is unmanned before starting.

(4) Immediately after the equipment is started, check whether the belt swing is within the required range, and whether there are other abnormal phenomena. Otherwise, it should be adjusted or shut down immediately.

(5) It is strictly forbidden to start the wire drawing machine and the dust collecting fan at the same time. It is strictly forbidden for the operator to leave the job after starting the machine.

www.chinawiredrawingmachine.com