Home > Exhibition > Content

Process quality and technical level of inverted vertical drawing machine

May 31, 2019

The inverted vertical drawing machine belongs to the steel wire drawing machine and is used for the drawing work of the metal wire. The equipment adopts the vertical downward working mode of the roll outlet, and can continuously pull 1-3 tons of wire in one time, and the finished product after processing directly falls. Entering the rewinding tray to facilitate deeper processing at a deeper level. The device has the dual functions of drawing and winding, and is suitable for various non-ferrous metal wires such as high, medium and low carbon steel bars and special-shaped steel wires.

Inverted vertical drawing machine are available in a variety of models. From the parameters, the models are divided into 800, 900, 1000, 1200, etc., drawing metal wires of different diameters, selecting rolls of different diameters and corresponding motor power. The inverted vertical wire drawing machine is drawn and integrated in one body, and directly collected into a disk after drawing, which is convenient for the next process. After the installation is complete, it is debugged.

We need to check that the installation is complete and check that the bolts are tight. Then, inject a proper amount of lubricating oil into the interior of the inverted vertical drawing machine, and at the same time, check the center position through the observation hole to ensure the height is suitable. In addition, care should be taken to ensure that there is no oil leakage in the body of the reduction gearbox. Then start it under no-load condition. At this time, you should pay attention to check whether its running state can be kept stable, whether there will be large noise, or obvious vibration problem. During the operation of the empty load, try to control each control button to control various actions such as starting, normal operation, and parking of the whole machine.

With the continuous development of technology and technology, people have higher requirements for the quality of various metal products. At the same time, as a common equipment, its technological level, product quality, output and variety have also made great progress. Prior to this, most of the companies engaged in related production work still used the previous production equipment, so they were far behind in terms of process level, production capacity and product quality. The appearance of the product effectively solves the improvement of the quality of the product, the increase of the output and the increase of the variety, and the manual unloading line has a small disc weight and low efficiency. It should be noted that before using the equipment of this technology, the metal wire needs to be pre-aligned in advance, which can improve the quality of the drawn wire.www.chinawiredrawingmachine.com