The inverted wire drawing machine is specially designed for continuous and non-twisting operations of the large plate during the working process. It is a wire drawing machine with dual functions of wire drawing and take-up. It is suitable for drawing high, medium and low carbon steel wire, special-shaped steel wire, stainless steel wire, thick non-ferrous metal wire, especially suitable for standard parts industry and shelf manufacturing.
Pay attention to the following four items when installing and using the inverted wire drawing machine:
(1) The installation foundation of the wire drawing machine must be very stable to avoid vibration;
(2) During installation, the drawing axis of the wire must be symmetrical with the center line of the die hole through debugging, so that the stress of the wire and the drawing die is uniform;
(3) Avoid frequent start and stop during the drawing process, because the friction caused by the tensile stress at the start of drawing is much greater than the friction during normal drawing, which will inevitably increase the wear of the mold.
(4) In addition, the wire used for drawing must undergo pretreatment: surface pretreatment and heat treatment.
a. Surface pretreatment: For wire with dirty surface and more impurities, it must be cleaned and dried before drawing.
For the wire with more oxide scale on the surface, it must be finely acidified and dried before being drawn.
For wire rods with peeling, pits, and heavy leather on the surface, they must be polished by a grinder before being drawn.
b. Heat treatment: For wires with excessive hardness or uneven hardness, annealing or tempering should be carried out to reduce the hardness first, and the wire should maintain good hardness uniformity before drawing.