The water tank wire drawing machine starts the synchronization requirement of the speed increase during the operation, and needs to keep the tension constant during the running process. The whole equipment needs to be synchronized when stopping, no broken wire and tension relaxation phenomenon, and the safety of the wire drawing machine Breaking protection required for production.
Operation requirements for water tank wire drawing machine
1. The water tank wire drawing machine should carefully read the drawings and technical data before processing, so that it can effectively avoid batch scrapping or waste.
2. When processing the water tank wire drawing machine, the drawing direction, the drawing surface and the correct selection of the drawing abrasive belt should be carefully determined according to the technical requirements.
3. Wear gloves in the whole process of processing, pay attention to the surface protection of the workpiece, prevent scratches, and cause damage to the surface of the workpiece.
4. Direct drawing of the unwashed workpiece of the water tank wire drawing machine
5. The finished workpiece should be handled gently and layered to prevent damage to the surface of the workpiece.
6. Clean and recycle the waste bins in time to ensure the normal operation of the fans.
Daily maintenance of water tank wire drawing machine
1. Keep the outside of the equipment clean and check that the gas supply line and quick connector are good.
2. Lubricate the upper and lower housings and the lifting screw (oil gun refueling).
3. Drain the water from the air filter.
4. Check the belt and make balance adjustments.www.chinawiredrawingmachine.com