The unique feature of the inverted wire drawing machine is that it is mainly applied to the continuous and non-twisting operation of the large plate. Since it can complete the drawing and winding work at the same time, it is easy to operate during the operation. Under normal circumstances, this equipment can pull high, medium and low carbon steel wire, and can also pull profiled steel wire, stainless steel wire and coarse gauge non-ferrous metal wire.
Judging from the current situation, this inverted wire drawing machine has a very outstanding effect especially in the fields of drawing standard parts and shelf manufacturing. Among them, the transmission system of the equipment is composed of strong narrow V-belt and standard reducer transmission. The main components include double-envelope worm gear pair, cycloidal pinwheel reducer, planetary reducer and hardened surface deceleration. And so on.
So what procedures should we follow when using this kind of wire drawing equipment? First of all, we must ensure that the lubrication parts of the inverted wire drawing machine have been fully lubricated; secondly, check whether the links of their parts are intact and loose. When the trolley and the drop frame are pulled into place, lower the fingers to allow the fingers to connect with the drop frame.
Then turn on the appropriate power supply as required, then turn on the AC main motor, let it run for a while, then put the wire drawing die into the mold box. Then thread the steel wire into the mold and press it, then hang one end of the wire cutter on the reel, let the wire rotate slowly for ten to twenty times, under the traction of the inverted wire drawing machine equipment, and then shut down. . Take the pull-down wire clamp to perform the retraction operation, and pay attention to the wire that has been removed to be placed in the drop frame.
Note that during the operation of the inverted wire drawing machine, it is important to observe its operating status closely to avoid accidents. When the drop frame is full, you can stop it. At this time, the pressure roller and the claw are released, and then the trolley is pushed out, the wire in the wire hanger is lifted out, and then pushed into the trolley. This process can be repeated.https://www.chinawiredrawingmachine.com/