Home > Exhibition > Content

Why the wire drawing machine host can't start and disconnect frequently

Aug 30, 2019

First of all, let's analyze why the wire drawing machine equipment has failed to start. In fact, there are many factors in this situation. One reason is that the control power switch of the device is not turned ON. At this time, we should turn the control power switch to ON.

The second reason may be due to the problem of disconnection shutdown during the last production process, or the failure to reset in time after the shutdown, then the reset can be solved at this time.

The third reason may be that the emergency stop button of the wire drawing device has not been turned off, and the button should be turned off at this time. The fourth reason is that the inverter cannot be turned on due to tripping. At this time, you can refer to the information displayed on the inverter display board, then turn off the main power supply, wait 30 seconds and then restart.

Another problem that is a headache is the frequent disconnection during the operation of the wire drawing machine. This will cause a lot of waste for us, so we must solve this problem in time. The reason for this problem is that there are many aspects. For example, it may be due to improper configuration of the eye mold used, the eye mold should be reconfigured.

In addition, it may be because the wire drawing machine equipment is running too fast, which causes the wire to break; or the quality of the wire itself is problematic, the wire should be replaced; or the lubricating fluid used is deteriorated, New and so on.

https://www.chinawiredrawingmachine.com/