Home > Exhibition > Content

Use water tank wire drawing machine need to grasp some points

Jun 27, 2018

During the operation of the water tank drawing machine, in order to meet the drawing requirements, relevant debugging needs to be done in advance. During commissioning, it is considered that the drawing of the water tank drawing machine equipment is mainly carried out by means of a mechanical shaft, and that these mechanical shafts are actually driven under the same main shaft, so it is necessary to grasp the following points:

 

First of all, during the operation of the water tank drawing machine equipment, due to the influence of certain factors, problems such as pitting, peeling, triangular mouth and burr may occur on the surface of the product. There are five reasons for this problem, including: 1. Problems with flashing, inclusions, shrinkage holes, etc.; 2. Poor quality of pickling; 3. The hole is not smooth and there is a certain deformation; 4. Lubrication Unreasonable; 5, tower wheel is not smooth and so on.

 

Second, during the operation of the water tank drawing machine, it is necessary to maintain its stability and reliability. Therefore, it needs to be flexibly controlled during operation to achieve the purpose of coordination. In addition, during the operation of the water tank wire drawing machine equipment, it is also necessary to use a cooling liquid for heat dissipation to prevent the quality of the wire drawing product from being adversely affected.http://www.chinawiredrawingmachine.com/