Home > Exhibition > Content

Use water tank type wire drawing machine safely

Nov 21, 2020

Under normal circumstances, in order to ensure the smooth completion of subsequent production operations, it is necessary to check the specific conditions of the water level, water quality, oil level, air pump, water tank, etc. before turning on the water tank drawing machine equipment. At the same time, pay attention to checking the motor and safety protection equipment to ensure that the water tank type wire drawing machine can be turned on under all normal conditions.

Of course, after completing the above inspection operations, the on-site staff also need to check and ensure that the spool winding switch of the water tank type wire drawing machine is in the off position. At the same time, the speed control knob of the electromagnetic speed governor needs to be adjusted to the lowest in the counterclockwise direction, and then operate according to the operating requirements. Such as starting the main motor, starting the clutch and so on.

Remember, during the operation of the water tank type wire drawing machine, the staff shall not directly touch all the transmission parts with their hands. In addition, it should be noted that in order to ensure that the equipment can run stably for a long time, the staff needs to adjust the speed control knob of the electromagnetic speed regulator to the middle and low speed position in advance, and then start the clutch and gradually adjust to the running speed. If the spool is found to be damaged, it needs to be replaced in time.

It should be noted that before completing the replacement operation, before turning on the water tank type wire drawing machine again, you need to adjust its inverter reset button first, and then restart according to the operating sequence. After starting the device, you need to perform a trial run to check its operating status. And can gradually increase the operating speed of the equipment.

In order to ensure safe production, no other people should stay nearby during the entire operation of the water tank drawing machine, and the staff should also pay attention to keeping a proper distance from the reel. In addition, it is necessary to regularly apply appropriate amount of lubricating oil to the bearings of each part of the water tank drawing machine.

https://www.chinawiredrawingmachine.com