Operators must abide by the relevant guidelines when operating the inverted wire drawing machine. Only this is enough to ensure that our production operations can be completed smoothly. First of all, the operator of the inverted wire drawing machine should be clearly designated, and the operator who is not in this position shall not operate the machine without consent.
In addition, no one is allowed to dismantle the safety protection equipment at will, nor is it allowed to replace the parts in between without permission. Secondly, it should be ensured that the jog switch of the equipment is kept active, and the time when not in use should be placed in a hidden place to prevent misoperation.
Operators should pay special attention to protect their personal safety when operating the piercing machine. Never put their hands on the roll of the piercing machine or put their hands on the roller of the piercing machine and use the piercing machine. The power supply should be turned off in time after completion. Wear protective glasses when connecting to prevent sparks from flying out and hurting people.
When the inverted wire drawing machine is working, the equipment shall not be inspected or repaired or cleaned to prevent accidents. Before opening the inverted vertical wire drawing machine, all the sundries on the equipment should be cleaned up to prevent getting involved in the equipment and causing trouble. Do not use the core to loosen the disk, which may be damaged. In addition, you should also be careful not to have personnel other than operators present around the equipment.
When operating the inverted wire drawing machine, if an open flame is found, it must be extinguished in time. If the craft cannot be extinguished, the power should be cut off, and then use a fire extinguisher to aim at the flame root to extinguish. Fire extinguishers after use should be stored in designated places.