Home > Exhibition > Content

Heavy-duty tank drawing machine electrical system and adjustment and maintenance

Jun 12, 2018

There are many types of wire drawing machines, one of which is called water tank drawing machine. Next, we mainly introduce some basic knowledge about heavy-duty water tank drawing machine, I hope everyone can understand it.

 

First, introduce the electrical system of the heavy-duty tank drawing machine:

In this system, there is a rotating whole machine, and all the supporting electrical and protective devices are installed in the electric control cabinet and the control box. The motor power is 130KW. The control equipment is mainly a cabinet-type electric control box and a control box. The start-up method is varistor start-up.

 

In actual production, in order to ensure that the heavy-duty water tank drawing machine has been in a good state of production, it is necessary to make appropriate adjustments and corresponding maintenance. For example, for the lubrication of the gearbox, it is recommended to add 20# gear oil before operation. The oil surface line should be immersed to three-fourths of the total length of the oil standard. Change the oil once in three months after use. When changing the oil, add kerosene for no-load cleaning, and then replace the gear oil once a year.

 

As for the heavy water tank drawing machine gearbox bearing should be checked once every three months, if you find the gap is too large should be adjusted. The specific method of adjustment is: remove the end cover of the bearing with excessive clearance, and reduce the thickness of the paper pad or the joint surface between the lathe turning end cap and the paper pad. The size of the turning amount depends on the tightness of the bearing. After the bearing adjustment is completed, it should be operated with no load and no bearing overheating will occur.

 

At the same time, it is very necessary for the adjustment and control of the take-up machine. Before starting the water tank drawing machine, it is necessary to add 20# gear oil to its take-up machine, and the oil surface line should reach two-thirds of the observation hole. Change the oil once in three months after use. When changing the oil, add kerosene for no-load cleaning, and then replace the gear oil once a year.

 

For the water tank wire drawing machine, the bearing of the wire take-up machine also needs to be checked once every three months, and the bearing clearance is adjusted to ensure the gear meshing accuracy. The specific method of adjustment is: Spindle turbulence, remove the end cover of the bearing with excessive clearance, thin the paper pad or the joint surface of the lathe turning end cap and paper pad, after the end cap is pressed, manually rotate the drum, Should ensure that the main and horizontal axis rotation. http://www.chinawiredrawingmachine.com/