Home > Exhibition > Content

Main working parameters of water tank drawing machine and adjustment and maintenance key points

May 04, 2018

As a user, in order to better understand and use the water tank drawing machine, it is necessary to have a simple understanding of the working parameters of the equipment before using the equipment. First of all, we generally divide the parameters of the water tank wire drawing machine into three parts, which are system parameters, working parameters and compensation parameters.

The system parameters of the water tank wire drawing machine mainly include: 1. The diameter of the line is the diameter of the input finished line, and the unit is mm; 2. Diameter of the cartridge, i.e., the diameter of the input reel and the unit is m; 3. Tube length refers to the length of the input reel and the unit is m; 4. Meter parameter, which is the circumference of the meter wheel, and the unit is m.

The working parameters of the water tank wire drawing machine mainly include: 1. Linear velocity, which is the speed of the main machine, and the unit is m/min; 2. Set the length, which is the total length of the finished product line, and the unit is m; 3. Line gap setting refers to the pitch of the finished product line and the unit is mm.

The compensation parameters of the water tank drawing machine mainly include: 1. The upper setting is the upper limit of the given feedback signal;

2. The lower setting refers to the lower limit of the given feedback signal; 3. The startup time delay refers to the delay time that the compensation action can take effect after the operation is set, and the unit is s; 4. Speed adjustment delay refers to the delay time when the speed is adjusted and the compensation action can take effect, and the unit is s; 5. Compensation scope, mainly indicating that the compensation action can affect the scope and the unit is mm; 6. Compensation amount refers to the action value of the compensation action, and the unit is mm.

At the same time, in the process of using water tank drawing machine equipment, some simple adjustment and maintenance knowledge are needed. During its operation, for example, to regularly for reducer lubrication for nursing, request to add the appropriate lubricating oil, normal use after every three months to replace a lubricating oil, to clean the tank in replacement. Also check the bearing, if the clearance is too large should be adjusted in time.

In addition, it is necessary to check the shaft of the wire drawing machine regularly during the use of the water tank drawing machine, so as to ensure good meshing accuracy and adjust if the clearance is too large. At the same time, we should also pay attention to the wear condition of the tank drawing machine tower wheel. If there is any wear, it should be repaired, and surface spraying should be carried out to protect it.http://www.chinawiredrawingmachine.com/